Bug Reports

Unable to stop ather-admin if any browser tabs are currently open to the admin site. Closing the tab, kills the websocket which then allows the service to stop.

Navigate to "Outbound Streams", click edit on an existing entry, then attempt to change either the "Stream Name" - Clicking on Save results in the backend data getting changed but without any UI response "Codec" - This works as expected "Sample Rate" - Clicking on Save results in the backend data getting changed but without any UI response "Packet Time (us)" - Clicking on Save does not change the backend data and without any UI response "Session ID" - Clicking on Save results in the backend data getting changed but without any UI response "Session Version" - Clicking on Save results in the backend data getting changed but without any UI response

Setup: Successfully created a configuration for a NUC that had an "Output Audio" Device entity that had a USB-to-3.5mm device selected. Everything was working great. A small change was made within the "Inbound Streams" page and then pressing "Load Config" again, the USB device assignment was lost and would no longer show in the drop down. When navigating to the Output Device config, the USB Audio device was no longer present in the drop down and showing as unassociated to any device. Navigating to the live view, it showed the audio device within the "Audio Configuration" area under the "Output Devices". I clicked on the Delete icon and then re-loaded the config. This brought back the audio immediately.? What is strange is that when navigating back to the "Audio Configuration" under the live view., the entry under "Output Devices" shows a blank name but 2 channels and a valid sampling rate.

Navigating to the "Stream Associations" by clicking on the icon within the "Outbound Streams" page presents a list of existing Stream Associations if previously configured. Attempting to modify and existing Stream Association entity by clicking on the edit icon, making the change and then pressing the save icon results in what appears to be an ineffective click where the Stream Association entity remains in edit mode and the save icon also remains. Clicking "Close" and then clicking on the Associations icon again shows that the requested change was not applied. The edit appears to be broken for now.

Initial state: Three Input Streams (Input-S1, Input-S2 & Input-S3) with each having 64 channels. Three Output Streams (Output-S1, Output-S2, Output-S3) with each having 64 channels. Channel ordering (sidenote): When navigating to the "Stream Associations" page, the order of the streams in the drop-down started with the 64 Input-S2 channels, then followed by the 64 Input-S3 channels, and then at the end, the 64 Input-S1 channels. It would be great if these were sorted alphabetically or optionally when added. Behavior/Issue To simplify the association processes, I deleted Input-S2, Input-S3, Output-S2, Output-S3. However, the channels from these four streams remained in the "Stream Associations" drop-down list even though they should have been deleted along with the Streams which doesn't appear to be the case.